Home / Knowledge / Haas UMC-500
Haas UMC-500
The Haas UMC-500 is a compact 40-taper universal machining center for 3+2 and simultaneous 5-axis work. Its published standard configuration combines 24 x 16 x 16 inch linear travels with B- and C-axis rotary motion, an 8,100-rpm inline direct-drive spindle, and a 30+1 side-mount tool changer.
- Builder: Haas Automation.
- Series: UMC Series.
- Lifecycle status: current.
Company overview
The Haas UMC-500 is a compact 40-taper universal machining center for 3+2 and simultaneous 5-axis work. Its published standard configuration combines 24 x 16 x 16 inch linear travels with B- and C-axis rotary motion, an 8,100-rpm inline direct-drive spindle, and a 30+1 side-mount tool changer.
Industries and applications
- Published maximum part swing is 18.0 in / 457 mm and standard platter diameter is 15.70 in / 400 mm.
- Five-axis usable work envelope is smaller than linear travels because the part and workholding must rotate and tilt without collision.
Technical and quote details
- X travel: 24.0 in / 610 mm.
- Y travel: 16.0 in / 406 mm.
- Z travel: 16.0 in / 406 mm.
- B travel: +120 to -35 degrees published swivel range.
- C travel: 360 degrees.
- Spindle interface: 40 taper.
- Spindle speed: 8,100 rpm standard.
- Spindle drive: inline direct drive.
- Tool capacity: 30+1 side-mount tool changer standard.
- Control: Haas Control.
- Control: Dynamic Work Offsets.
- Control: Tool Center Point Control.
- Control: Ethernet.
- Control: WiFi.
- Control: HaasConnect.
- Control: Rigid tapping.
Selection notes
Variables to validate
- Linear travels do not represent the collision-free five-axis work envelope.
- Pallet-pool, platter, workholding, probing, coolant, and automation configurations change usable capacity and should be recorded explicitly.
- Haas notes that models and layout drawings can lag continual design improvements; serial-specific documentation should control installation or service decisions.