Home / Knowledge / Allied Machine GEN2 T-A vs Guhring RT 100 FB
Allied Machine GEN2 T-A vs Guhring RT 100 FB
Allied Machine GEN2 T-A and Guhring RT 100 FB are documented holemaking systems with different product architecture and application priorities. Allied Machine GEN2 T-A is a distinct T-A-system generation combining Notch Point geometry and AM200 coating options with compatible GEN2 holders and inserts. Guhring RT 100 FB Series 6596 is a two-flute, coolant-through flat-bottom carbide drill.
Side-by-side comparison
| Category | Allied Machine GEN2 T-A | Guhring RT 100 FB |
|---|---|---|
| System architecture | Allied describes GEN2 T-A using Notch Point geometry and AM200 coating within its replaceable-insert drill directory. | Series 6596 is approximately 3xD with a 180-degree point. |
| Documented application focus | Production drilling where an established GEN2 T-A assembly is being replaced, expanded, or requoted. | Flat-bottom holes and low-burr exits. |
| Technical selection detail | GEN2 T-A and original T-A share literature coverage but remain distinct product generations. | It uses carbide, nano-FIREX coating, internal coolant, and an HA shank. |
| Primary documented constraint | Shared branding does not establish cross-generation holder and insert compatibility. | Series 6596 and micro Series 6496 are not interchangeable. |
| Manufacturer-guided selection | Preserve the installed GEN2 body and insert numbers, then compare any current alternative on diameter, L/D, geometry, coolant, holder interface, and required process change. | Store series, EDP, code, diameter, L/D, point, shank, coating, coolant, and catalog revision. |
Best fit by application
Allied Machine GEN2 T-A
- Production drilling where an established GEN2 T-A assembly is being replaced, expanded, or requoted.
- Preserve the installed GEN2 body and insert numbers, then compare any current alternative on diameter, L/D, geometry, coolant, holder interface, and required process change.
Guhring RT 100 FB
- Flat-bottom holes and low-burr exits.
- Store series, EDP, code, diameter, L/D, point, shank, coating, coolant, and catalog revision.
Selection notes
Use GEN2 T-A when its documented application focus and technical configuration match the operation more closely; use RT 100 FB when its documented architecture and constraints provide the better fit.
Compare complete configured assemblies and current manufacturer data rather than treating either family name as one universal item.
Variables to validate
- GEN2 T-A: Shared branding does not establish cross-generation holder and insert compatibility.
- RT 100 FB: Series 6596 and micro Series 6496 are not interchangeable.
- Normalize diameter or cutter size, reach, interface, work material, machine conditions, coolant, and acceptance criteria before comparing performance or cost.
Official product references
We work to keep this information reliable, but specifications and availability can change. Verify critical details with the manufacturer through the official resources above.